International Ph: +61 2 8338 9997  
 

Product Range



Key Properties

Green Building VOC Comparison Key Differenciators Application Methodolgy TDS and MSDS

Feature Articles

VOC

Rust

Timber

Ultra-NuPave

  • Introduction
  • Advantages
  • Uses
  • Application
  • Technical Info
  • Cleanup
  • Storage

Ultra-NuPave is an acrylic-based floor coating for high impact areas.
The product's principal characteristic is to build high films that cover irregular surfaces. Similar to the other Ultralast products, Ultra-NuPave has good waterproofing qualities.
Ultra-NuPave A/S (anti slip) has excellent abrasion resistance ideal for vibrating structures, and is nontoxic.

After 5 months of a leading brand After 18 months with Ultra-NuPave
Concrete Seal on Stairs Concrete Seal on Stairs with Ultralast
After 5 months of a leading brand After 18 months with Ultra-NuPave
Concrete Seal on Stairs Concrete Seal on Stairs with Ultralast

Ultra-NuPave A/S flooring product recently underwent Anticorrosion and Slip testing by CSIRO, at the request of both the NSW State Rail Authority and Woolworths. The tests produced a remarkable result: a rating of R12, making Ultra-NuPave A/S the first coating ever to achieve this rating, previously only possible with tiles. CSIRO Test Report No. 4149s certifies slip resistance classification of new pedestrian surface material (Ultra-NuPave A/S) at a mean overall acceptance angle of 30.7°, officially achieving the R12 rating.

  • High film builds to cover irregular surfaces
  • Good impact resistance. Suitable for floor surfaces
  • Good waterproofing qualities
  • Has excellent abrasion resistance ideal for vibrating structures i.e. bridges and airports
  • Non-toxic and ZERO V.O.C.
  • Restaurants / Cafes can be painted directly over vinyl or ceramic tiles in high-traffic areas where health and safety are paramount. Ultra-NuPave A/S is CSIRO R12 rated but not too rough a surface to prevent effective cleaning.
  • Public walkways / thorough fares, bike paths - Ideal grip is provided without the risk of too rough a surface that may tear skin should a fall occur.
  • Factories / Food production - a courser version is available where food fats and oils create build up on factory floors

Supplied ready for application. Stir contents thoroughly before application. Clean equipment with water before touch dry state. If the Ultra-NuPave is applied to thick, there will be cracks. If it is necessary that the Ultra-NuPave must be a thick application, it should be done in layers.

Ensure all traces of loose friable materials; dirt, oil, and debris are removed. Freshly cast conventional screeds must be allowed to dry thoroughly before application of Ultra-BondFirst and Ultra-NuPave. Bulk concrete to cure for 28 days minimum before application. Surfaces to be primed with Ultra-BondFirst.

Surface Preparation

Storage and application
Room (moderate) temperature, tightly closed (sealed)
Colour
Any
Finish
Matt
Solvent
Water
Thinner
Must not be thinned
Solids (%) by mass
Minimum 90%
Solids (%) by volume
Minimum 95%
Flash point
Waterborne and not flammable
Shelf and pot life
2 years +
Thickness
Minimum of 1 mm
Drying time
At 20°C and 1mm - Touch dry (30 minutes) Full cure (24 hours)
Spreading rate
1 litre per m2 at 1mm thickness (recommended)
Minimum 1 litre per 4m2 at 250µm thickness
 
Material Safety Data Sheet

Clean all equipment thoroughly with water immediately after use.

Keep containers well sealed.
Store at moderate temperatures.