Ultra-BondFirst
- Introduction
- Advantages
- Uses
- Application
- Technical Info
- Cleanup
- Storage
Ultra-BondFirst is a highly acrylic water based penetrating primer or undercoat that has excellent flexibility and impact resistant properties on all surfaces it's applied to. Ultra-Bond is suitable for application over old and new concrete, slates, bricks, plaster, asbestos, roof tiles, hard boards, chip boards; aluminium, galvanized steel, painted areas, etc. Other major advantages of the product include:
- Deep penetration allows the primer to gain a tough durable grip on the surface it's applied to, creating a long-lasting quality coating
- Low viscosity
- Waterproofing properties
- Excellent permeability
- Excellent adhesion of Ultralast product
- The Bond has a high fire and heat resistance level
- No chipping or scaling
- Non-toxic: great for the families, the applicators and the environment
- Odourless on application: People can move in and out of the painting environment with no upset due to toxic smell; pets are safe
- Corrosion resistance
- Ultra Violet resistance
- The Bond has a resistance to fungus and chemical substances such as acid, alkaline, etc
- Deep penetration
- Waterproofing property
- Excellent permeability
- Good adhesion of the top coat
- High fire resistance
- No chipping or scaling
- Anti-fungus, chemicals resistance such as acid, alkaline etc
- Non-toxic and odourless
- Heat resistance
- Ultra Violet resistance
- Corrosion resistance
Ultra-BondFirst is suitable for application over the following surfaces:
- Old and new concrete
- Slates
- Bricks
- Plaster
- Roof tiles
- Hard boards
- Chip boards
- Aluminium
- Galvanized steel
- Pre painted areas
- Remove laitance, oil, grease, fat deposits, and chemical components form the surface.
- Concrete should be left at least 28 days before application.
- Old weathering surfaces should be stripped down to remove lose adhesion and flake metals.
- The affected area should be washed or hosed down with water before application.
Surface Preparation
- Storage conditions
- Room (moderate) temperature, tightly closed (sealed)
- Colours
- Wet - milky colour Dry - transparent
- Solid (%) by volume
- 18%
- Gloss
- Slightly sheen
- Water resistance
- Excellent
- Spreading rate
- 12-18 m2 per litre at dried film thickness of 18 microns (Smooth surface, 1 coat)
Clean all equipment thoroughly with water immediately after use.
Keep containers well sealed.
Store at moderate temperatures.